16-fold binary output / 8-fold blind actuator

CODE: EK-FF1-TP

Description

The Ekinex® EK-FF1-TP binary output / blind actuator allows to command 16 groups of loads or control 8 drives for motorised blinds independently. The device is fitted with membrane pushbuttons for manual command (even in the absence of bus power) and LED’s for status indication; a pushbutton allows to switch between automatic and manual operation modes. The device integrates a KNX bus communication module and is realized for mounting on a standard 35 mm DIN-rail. The device is supplied by the KNX bus and requires an additional 230 Vac power supply to operate.

Technical data

Power supply

Voltage auxiliary 100-230 Vac 50/60 Hz
Voltage control section 30 Vdc by KNX bus
Current consumption from bus < 10 mA
Power on bus < 240 mW

Outputs

Number: 16 or 8 independent channels (depending on device use)
Nominal voltage (Un): 100-230 Vac 50/60Hz
Nominal current (In): max 16 (10) A (both @100Vac and @230Vac)
Max. switched power: max 4000 VA @250Vac

Delivery

Delivery includes a terminal block for connection to the bus.

Functions / Features

Plastic casing
Frontal programming pushbutton and LED
Membrane keyboard with LED’s for status indication
Pushbutton for switching operating mode (normal / programming)
Connection to bus line with KNX terminal block
Connection of outputs and 230 Vac power supply with screw terminals
Overvoltage class III (according to EN 60664-1)
Classification climatic 3K5 and mechanical 3M2 (according to EN 50491-2)
Pollution degree 2 (according to IEC 60664-1)
Installation on 35 mm rail (according to EN 60715)
8 modular units (1 MU = 18 mm)
IP20 protection degree (installed device)
Weight 595 g

Configurationa and commissioning

A detailed description of the parameters can be found in the application manual of the device. Configuration and commissioning require ETS5 or later versions. ETS application program: APEKFF1TP##.knxprod (## = release).

Download

Datasheet - v.2.1 (07/09/2021)

Instructions

Application manual - v.3.1 (07/12/2022)

Application software for ETS - v.0.4 (14/12/2022)

Drawing

Conformity declaration - v.1.0 (20/01/2019)

KNX certification

This website or its third party tools use cookies, which are necessary to its functioning and required to achieve the purposes illustrated in the cookie policy. If you want to know more or withdraw your consent to all or some of the cookies, please refer to the cookie policy. By closing this banner, scrolling this page, clicking a link or continuing to browse otherwise, you agree to the use of cookies.