The Ekinex® multisensor with controller is a KNX S-mode device for independent temperature control of a room or building area. The module includes 3 sensors: temperature, humidity percentage and air quality, expressed in terms of TVOC (Total Volatile Organic Compounds) or CO2 equivalent. It can also function as a controller for these three quantities, valid for a single zone to be controlled. The front LEDs indicate the heating, cooling, dehumidification, humidification and TVOC or CO2 threshold status. The push-button and the programming LED are located on the front in the area below the button. The device integrates a KNX bus communication module and is intended for mounting onto a wall mounting box; it is supplied by a SELV voltage directly from the KNX bus and does not require any auxiliary power supply.
Technical data
- 30 Vdc power supply by KNX bus
- Current consumption from bus < 13 mA
- Max. bus power < 390 mW
Delivery
Delivery includes a terminal block for connection to the bus, two pairs of fixing screws.
Pushbutton
The 4-fold pushbutton of Ekinex® 71 series commands loads on/off switching, controls the dimming of lighting devices, controls motor drives for shutters or executes any other programmable command and control function. Thanks to the integrated temperature sensor, the pushbutton can work as a thermostat for a room or a zone. The LED can be chosen in the colour combinations blue / green or white / red. The device integrates a KNX bus communication module and is intended for mounting onto a wall mounting box; it is powered by a SELV voltage directly from the KNX bus and does not require any auxiliary power supply.
Technical data
- 30 Vdc power supply by KNX bus
- Current consumption from bus < 15 mA
Delivery
Delivery includes a terminal block for connection to the bus, two pairs of fixing screws.
| Code |
LED colours |
Mounting |
| EK-E13-TP-BG |
blue / green |
with double frame Form or Flank version, without frame (‘NF version) |
| EK-E13-TP-RW |
red / white |
Accessories
The following accessories are available to be ordered separately:
- 1 full front cover with 60 x 60 mm modularity
- set of 1 square rocker, 2 vertical rectangular rockers, 4 square rockers or 4 horizontal rectangular rockers
- double frame Form or Flank version
- double plate with 60 x 60 mm window
- a plastic adapter
- metal support for installation onto round or square mounting box (fixing holes 71 mm apart)
.png)
.png)
